Hi folks,
I am using Creo Elements / Direct Modeling Express. I am trying to loft through three profiles on three workplanes in a workplane set. The profiles are fairly simple shapes with four vertices each. But one of the workplanes is perpendicular to another one and one edge of the profile on one is coextensive with one edge of a profile in another workplane (and I think that may be causing a problem). Anyway, when I try to create an appropriate matchline I get an error message which says: "If a vertex lies in another workplane, a vertex must be at the same position in the other workplane." I don't know what that means and cannot create a loft between the three profiles on the three workplanes. What must I do to create this loft? I have attached a drawing with the three workplanes so you can see what I am talking about.
Thanks in advance,
Vincent